Is300 Dual Cup Holder

IS300, 240SX, FR-S, BRZ, 86 & More

Upgrade your interior with a modular, heavy-duty 3D printed cup holder designed for large fountain drinks and built around a removable mounting system.

Unlike a traditional fixed cup holder, our design uses a separate mounting base and removable cup-holder module, allowing you to remove or swap the holder while leaving the mounting base installed in your vehicle.

Vehicle Compatibility

Designed to fit:

• Lexus IS300

• Nissan 240SX

• Scion FR-S

• Subaru BRZ

• Toyota 86

• May also fit other vehicles with suitable mounting locations

Because every vehicle interior is different, please verify that you have a suitable mounting location before ordering.

IMPORTANT — INSTALLATION

This product requires drilling into the vehicle's interior panel for installation.

The mounting base is secured to the vehicle using screws. Installation requires drilling holes into the mounting surface.

This is not a factory plug-in or completely non-permanent installation.

Please verify the mounting location before drilling. The buyer is responsible for confirming that the selected location is suitable and that there are no wires, airbags, structural components, or other obstructions behind the panel.

Large 4" Cup Opening

The holder features an approximately 4-inch inside diameter with a 3.5-inch deep gripping area, designed to accommodate large fountain drinks.

The large opening is intended for:

• 32 oz fountain drinks

• Large fast-food drinks

• Large beverage cups

• Other similarly sized containers

Modular Sizing Inserts

Want to use smaller drinks?

Optional TPU sizing inserts are available to reduce the opening for smaller cups and cans.

This allows one holder to accommodate a wider range of drink sizes without needing a completely different cup holder.

Built for Real-World Use

The cup holder is printed from ASA, providing a durable material choice for automotive interiors.

The mounting system incorporates:

• Heat-set threaded inserts

• M4 hardware

• Removable cup-holder module

• Reinforced mounting interface

• Replaceable sizing inserts

The result is a cup holder designed to be more than a simple 3D-printed piece — it's a modular mounting system that can be expanded with additional accessories in the future.

Choose Your Configuration

Single Cup Holder

• One large 4" cup position

• Removable mounting system

• Mounting hardware included

Dual Cup Holder

• Two large 4" cup positions

• Removable mounting system

• Mounting hardware included

Optional TPU Inserts

• Designed for smaller drinks

• Flexible TPU construction

• Sold separately or as an add-on

Please Note

This is a custom 3D-printed automotive accessory, not an OEM Toyota, Subaru, Scion, Lexus, or Nissan product.

Minor layer lines and variations are normal characteristics of 3D-printed parts.

Vehicle fitment can vary depending on interior configuration and modifications. Installation requires drilling into the mounting panel.

Professional installation is recommended if you are uncomfortable drilling into your vehicle.

Please verify your vehicle and mounting location before ordering.